Holder for Arduino Raspberry pi Breadboard Kit 7 in 1 Kuman Rab One Piece RPI GPIO Breakout Expansion Board 830 Point Solderless PCB for Arduino UNO R3 MEGA 2560 & Raspberry PI 3B+ +/Zero/Zero W SC23

Holder for Arduino Raspberry pi Breadboard Kit 7 in 1 Kuman Rab One Piece RPI GPIO Breakout Expansion Board 830 Point Solderless PCB for Arduino UNO R3 MEGA 2560 & Raspberry PI 3B+ +/Zero/Zero W SC23

Introduction:
This RAB holder kit contains all necessary components for a simple experiment, including RPi GPIO expansion board, a flat ribbon cable, a breadboard, a wide variety of jumper wires, a Rab holder, 9 LED's and ten 1 K Power limitation resistance so that you can experiment as soon as the.
With this kit, you can your Arduino board, Raspberry Pi 3B/2B/1B//Zero/Zero W and bread board on the Rab holder Fix, no Unvorsichtige Short Circuits on one piece of metal the table or by some metal parts including. RPi GPIO expansion board flex ribbon cable for Raspberry Pi 3B/2B/1B +/Zero/Zero with even more storage we have 65 pieces jumper wires each of varying length in a range of colours, so you can just plug into the driver board and breadboard, without complicated soldering to worry about all that.
Specifications:
Rab holder size (Height x Width x Depth): 202,7 x 136,5 mm (7,98 x 5,37 inches)
Box Contents:
1 x Rab holder
1 x GPIO 40P break out board for Raspberry Pi 3B/2B/1B +/Zero/Zero W
1 x 20 cm FC40 40-pin Flat Rainbow Ribbon Cable
1 x 830 Point Breadboard
65 x Jumper Wire
10 x 1 KΩ resistor
9 LED (3 red, 3 yellow and 3 green)
1 x Screw Driver
4 x M3 * 6 Screws, 4 x PWM2

Message from the seller

Full refund after review by paypal, cover fees
More Review it
This product was withdrawn from tests.